1-20 (E)
SNC-WR632C/WR602C
1-4-10. FCB
Assembly
1. Remove the cabinet. (Refer to Section 1-3.)
2. Remove the TILT block. (Refer to Section 1-4-3.)
3. Remove the side cabinet and camera cabinet. (Refer to steps 3 to 9 in Section 1-4-8.)
4. Remove the CN-3521 board. (Refer to Section 1-4-9.)
5. Remove the two screws (BSW2
x
6), then remove the front cabinet.
6. Remove the four screws (PSW2
x
6), then remove the FCB assembly.
7. Disconnect the flexible flat cable from the connector on the FCB assembly.
8. To install, reverse the removal procedure.
BSW
2
)
6
PSW2
)
6
Front cabinet
FCB assembly
Connector
Flexible flat cable
