Sony SNC-VB600B, User Manual

Page: 17 / 39

Ad
minis
tra
ting t
he Camer
a
Configuring the System — System Menu
17
Select On when you install the camera on a rack, etc.
Note
Privacy mask positions and motion detection areas, etc.,
will not be inverted, even if the
On/Off setting of the
inverted image is switched. To invert the image, make
the setting again.
OK/Cancel
See “Buttons common to every menu” on page 14.
Initialize Tab
Reboot
Used when rebooting the system.
Click
Reboot , and the message “This System will be
rebooted. Are you sure?” appears. Click OK to reboot
the camera. It takes about two minutes to restart.
Factory default
Resets the camera to the factory settings.
Retain current network settings
When this item is checked, only the current network
settings will be retained after reset.
Click
Factory default , and the message “This System
will be rebooted. Are you sure?” appears.
When you click
OK , the network indicator on the
camera starts to blink. After adjustments of the default
settings have finished, the camera reboots automatically.
Do not turn off the camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of this unit while pressing the reset
button on the camera. For details, refer to the supplied
Installation Manual.
Format SD memory card
You can format a SD memory card (not supplied)
inserted into the SD card slot of the camera. When you
click
Format , a confirming message appears. Click OK
to start formatting. Any files and folders stored in the SD
memory card will be deleted.
Notes
• Before formatting, set Edge Storage in the Execution
Condition tab of the Action output menu to Off , to
write-protect the SD memory card.
• Do not activate the Format SD memory card
function when no card is inserted into the SD card slot.
Backup setting data
Saves the setting data of the camera in a file.
Click
Save , and follow the instructions on the Web
browser to specify the folder and save the setting data of
the camera.
The file name preset at the factory is “snc-vb600.cfg”
for SNC-VB600.
Restore setting
Loads the stored setting data of the camera.
Click
Browse... and select the file in which the setting
data is stored. Click OK , and the camera is adjusted
according to the loaded data.
Restore the privacy masking setting
If you select this, the stored setting data of the camera
and the privacy masking data are loaded.
Note
With Restore setting , some items in the Network menu
(page 23) cannot be restored.
System log Tab
The data of the software activity of the camera is
recorded in this log. It includes data that is useful if a
problem occurs.
Click
Reload to reload the latest data.
Access log Tab
The access record of the camera is displayed.
Click
Reload to reload the latest data.