Location and Function of Parts and Controls
12
RGB button:
to monitor the signal through the video
input (RGB) connectors.
COMPONENT button:
to monitor the signal
through the video input (component) connectors.
A-1 button:
to monitor the signal from option slot
A-1.
A-2 button:
to monitor the signal from option slot
A-2.
B-1 button:
to monitor the signal from option slot
B-1.
B-2 button:
to monitor the signal from option slot
B-2.
COMPUTER button:
to monitor the signal through
the COMPUTER SIGNAL IN connector.
k
APA (Auto Pixel Alignment) button
Adjusts the picture automatically to maximum clarity
while a signal is input from a computer. For finer
according to the input signal, see “DOT PHASE” on
page 24.
The operation is stopped by pressing the MENU or
RESET button during the APA operation. When the
menu screen is displayed, the APA does not function.
l
SCAN select button
You can change the scan size of the picture. When you
press the button, the scan size is changed to normal scan
(5% over scan), 0% scan, FULL or ZOOM set on the
menu (see page 27).
m
ASPECT select button
Sets the aspect ratio of the picture, 4:3 or 16:9.
Note
When a 16:9 signal is displayed, black bars appear in the
upper and lower positions of the display because the
screen size is 15:9. This is not a malfunction. (See
SCAN on page 27/28.)
n
MARKER button
When the button is pressed, an area marker is displayed.
Set the safety area size in the menu screen.
o
BLUE ONLY button
Press this button to eliminate the red and green signals.
Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
“chroma” and “phase” adjustments and observation of
VCR noise.
p
MONO button
Press this button to display a monochrome picture.
When the buttons is pressed again, the monitor switches
automatically to color mode.
q
HV DELAY button
Press to observe the horizontal and vertical sync signals
at the same time.
r
Speakers
The audio signal which is selected by the input select
button on the front panel is output.
When an analog video signal is input, the signal which
is set in the USER CONFIG menu is output (see page 15
and 26).
When an input adaptor is attached, the channel which is
set in the OPTION CONFIG menu is output (see
page 29).
The audio signals from the speakers are output from the
AUDIO MONITOR OUT connector on the rear (see
page 15).
