Sony MEU-WX1, Operating Instructions Manual

Page: 27 / 34

Adjustment Using the Menus
27
MARKER When the frame of the film is
displayed on the screen, select the
aspect ratio according to the film.
• When 16:9 aspect ratio is
selected with the ASPECT
button
You can select from among
4:3, 15:9, 14:9, 13:9, 1.85:1,
2.35:1, 1.85:1 & 4:3 and
OFF.
• When 4:3 aspect ratio is
selected with the ASPECT
button
You can select from among
16:9 and OFF.
CENTER MARKER Select ON to display the center
mark of the picture and OFF not to
display.
SAFETY AREA Select the safe area size for the
aspect ratio determined by the
ASPECT button.
You can select from among OFF,
80%, 85%, 88%, 90% and 93%.
MARKER LEVEL Sets the luminance to display the
MARKER and SAFETY AREA.
When the setting is low, the marker
is displayed dark.
MARKER MAT Selects whether you put mat on the
outside of the marker display.
•
OFF : No mat is put.
• HALF : Gray mat is put.
• BLACK : Black mat is put.
PIC DELAY MIN Selects to set the delay by the
picture processing to the minimum
level when the NTSC, PAL, 480/
60I or 575/50I signal is input.
•
OFF: Mode for giving
precedence to the picture
quality. It takes longer than “1”
or “2” for processing the picture.
• 1: The processing time is short
and this is a mode suitable for an
animation. Even when the
picture is constructed by one
field such as the proxy picture of
XDCAM, a smooth picture is
displayed.
• 2: The processing time is short
and this is a mode suitable for a
still picture. As the line flicker
is displayed in this mode, it is
available for checking the line
flicker of the telop work and so
on. When “2” is selected, V
SHARPNESS (page 23) does
not work.
Submenu Setting
SCAN Sets the scan size of the picture.
Select from “FULL” and “ZOOM”
mode. The displayed picture differs
according to the monitor used and
the selected mode (see “When a 4:3
monitor is used” and “When a 15:9
monitor is used” on page 28).
Note
When inputting the 1035/60I
signal, the signal format is
displayed as 1080/60I on the
screen. A slightly squashed picture
is displayed at a little lower
position, because the picture is
displayed in 1035/1080 picture
ratio on a 16:9 screen. Adjust the
position to the center using the
SHIFT V setting (on page 23).
Submenu Setting