masterpage:Left
(3 column)
filename[F:\My Document\mds-
s50\4230403131\4230403131\423040313MDSS50U2\GB05OPE-U2.fm]
model name1[MDS-S50]]
[4-230-403-13(1)]
10
Recording tips (continued)
Tips
•
During recording to an MD in LP2 or LP4 Stereo
mode, the MD LP indicator lights up when you press
z
in step 3 above.
•
The deck is set at the factory to add “LP:” at the
beginning of a track name automatically. This
indication is displayed when the track is played on a
deck that does not support long-time recording.
To turn off this function, do the following procedure.
1 While the deck is stopped or playing,
press MENU/NO twice.
“Setup Menu” appears in the display.
2 Turn AMS (or press
.
/
>
repeatedly)
until “LPstamp On” (factory setting)
appears, then press AMS or YES.
3 Turn AMS (or press
.
/
>
repeatedly)
to select “LPstamp Off”, and then press
AMS or YES.
4 Press MENU/NO.
To add “LP:” automatically again, select “LPstamp
On” in step 3 above.
Notes
•
The recorded "LP:" is a confirmation stamp that is
displayed to indicate that the track cannot be played
back on a deck that does not support MD LP mode.
It is not displayed on decks that support MD LP
mode.
•
If "LPstamp:On" is set, "LP:" is recorded as part of
the track name, so the number of characters that can
be input in a single MD is reduced. Furthermore,
"LP:" is automatically copied if the track name is
copied or if the track is divided by using the Divide
function.
•
MDs recorded in MD LP (LP2 or LP4 Stereo) mode
should be played back on a deck that supports MD
LP mode. These MDs cannot be played back on
other decks.
•
Even if you press REC MODE during recording or
recording pause, you cannot change the recording
mode.
•
Even if you press REC MODE repeatedly to select
MONO, the monitor signal during recording does
not become monaural.
Marking track numbers while
recording
— Manual /Automatic Track Marking
You can mark track numbers either manually or
automatically while recording. By marking
track numbers at specific points, you can
quickly locate the points later or edit the MD
easily.
Marking track numbers manually
(Manual Track Marking)
While recording, press
z
at the point
where you want to add a track number.
Marking track numbers
automatically (Automatic Track
Marking)
When recording from a CD player or MD deck
connected to a DIGITAL IN connector, the deck
marks track numbers in the same sequence as
the source. When recording from other sources
connected to the DIGITAL IN connector or a
source connected to the ANALOG IN jacks, do
the procedure below to mark track numbers
automatically. However, you cannot mark track
numbers automatically if the sound source to be
recorded is noisy (e.g., tapes or radio
programs).
1
While the deck is stopped, press MENU/
NO twice.
“Setup Menu” appears in the display.
2
Turn AMS (or press
.
/
>
repeatedly) until “T.Mark Lsync”
appears, then press AMS or YES.
3
Turn AMS (or press
.
/
>
repeatedly) to select the setting, then
press AMS or YES.
To
Select
Turn on Automatic
Track Marking
T.Mark Lsync (factory
setting)
Turn off Automatic
Track Marking
T.Mark Off
