Playing CDs
Getting Started
27
Enjoying Playback Using the PBC Functions
Enjoying Playback Using the PBC Functions
Additional Information
Precautions
On safety
• Caution — The use of optical instruments with this
product will increase eye hazard.
• Should any solid object or liquid fall into the cabinet,
unplug the player and have it checked by qualified
personnel before operating it any further.
On power sources
• Before operating the player, check that the operating
voltage of the player is identical with your local power
supply. The operating voltage is indicated on the
nameplate at the rear of the player.
• The player is not disconnected from the AC power source
(mains) as long as it is connected to the wall outlet, even if
the player itself has been turned off.
• If you are not going to use the player for a long time, be
sure to disconnect the player from the wall outlet. To
disconnect the AC power cord (mains lead), grasp the
plug itself; never pull the cord.
• AC power cord must be changed only at the qualified
service shop.
On placement
• Place the player in a location with adequate ventilation to
prevent heat build-up in the player.
• Do not place the player on a soft surface such as a rug that
might block the ventilation holes on the bottom.
• Do not place the player in a location near heat sources, or
in a place subject to direct sunlight, excessive dust or
mechanical shock.
On operation
If the player is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture may
condense on the lenses inside the player. Should this occur,
the player may not operate properly. In this case, remove the
disc and leave the player turned on for about an hour until
the moisture evaporates.
On adjusting volume
Do not turn up the volume while listening to a portion with
very low level inputs or no audio signals. If you do, the
speakers may be damaged when a peak level portion is
played.
On cleaning
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with a mild detergent solution. Do not
use any type of abrasive pad, scouring powder or solvent
such as alcohol or benzine.
On transportation
See page 6.
On disc tray
Do not pull or push the disc tray forcefully by hand. It may
damage the player.
If you have any questions or problems concerning your
player, please consult your nearest Sony dealer.
3
Press the number buttons (1 - 10/0) to select the
scene.
To enter “0”, use the button 10/0.
Example: To select scene number 103
Press 1, then 10/0 and 3.
The selected scene number appears on the TV
screen.
TV screen
SCENE 103 (1 – 312)
If you’ve made a mistake
Press CLEAR, then press the correct number button.
4
Press
·
to start playing from the selected scene.
The player automatically starts PBC Playback
(page 25).
z
You can check the scene number while playing a disc
Press ON SCREEN repeatedly to select ON SCREEN 2
display mode (see page 10). The scene numbers appear
on the upper left side of the TV screen.
Notes
• Some discs don’t allow you to start playing from a
particular scene. In this case, when you do the task before
you start playing, the player starts playing from scene 1.
When you do the task while playing a disc, the player
starts playing from the current scene.
• Some discs don’t display the selected scene on the TV
screen.
• When you select ON SCREEN OFF display mode, no
information is shown on the TV screen.
Selected scene number
Enjoying Playback Using the PBC Functions
