Sony LBT-N355KR, Operating Instructions Manual, Page: 12 / 32

Chapter 3: the Radio
EN
12
Listening to the Radio
Presetting Radio Stations
Playing Preset Radio
Stations
Chapter 3:
the
Radio
Listening to the Radio
When you want to play a radio programme,
you can have the tuner automatically scan
the radio frequencies and tune in the
stations with clear signals. This feature
saves you time in searching for stations
with clear signals.
However, stations with weak signals may
be skipped by automatic tuning. Manually
tune in stations with weak signals.
1
Press TUNER/BAND repeatedly until
the band you want appears and in the
display.
As you press this button, the band
changes as follows:
FM
Z z
AM
2
Press TUNING MODE repeatedly until
“AUTO” appears in the display.
3
Press /– buttons (or /
on the remote).
The tuner starts scanning radio
frequencies, and stops when it finds a
clear station. “TUNED” appears in the
display. “STEREO” also appears if the
FM station tuned in is broadcasting in
stereo.
3,4
2
1
STEREO/
MONO
4
If you don’t want to listen to the
selected station, press /– (or
/ on the remote) buttons to restart
the scan.
SYSTEM
POWER ON
CLIP
63 125 250 500 1k 2k 4k 8k 16k (Hz)
TUNER
VOLUME
MHz
MANUAL
CLIP
DISC PROGRAM
63 125 250 500 1k 2k 4k 8k 16k (Hz)
TUNER
VOLUME
MHz
AUTO
CLIP
DISC PROGRAM
63 125 250 500 1k 2k 4k 8k 16k (Hz)
TUNER
VOLUME
TUNED STEREO
MHz
AUTO
When the desired station is not
tuned in
Automatic tuning may skip the stations
with weak signals and continue scanning
without a stop. In this case, tune in the
station manually.
1 Press TUNING MODE repeatedly until
“MANUAL” appears in the display.
2
Press /– buttons repeatedly
until the desired station is tuned in.
To improve AM broadcast reception
Reorient the supplied AM loop aerial for
AM.
To change the AM tuning interval
The AM tuning interval is preset to 9 kHz
(10 kHz in some areas) at the factory. If you
need to change the interval, do as follows:
1
Turn on the power.
2
Change the band to AM.
3 Turn off the power.
4 Turn the power back on while pressing
ENTER/NEXT.
After changing the AM tuning interval,
reset the preset AM radio stations. To reset
the interval to the factory setting, follow the
same procedure.
When an FM programme is not received
clearly
Press STEREO/MONO on the unit so that
“MONO” appears in the display. There will
be no stereo effect, but the reception will
improve. Press STEREO/MONO again to
restore the stereo effect.
One Touch Play feature
Press TUNER/BAND (or TUNER/BAND
on the remote) when the power is off or
when you are listening to another sound
source.
You can listen to the last received station
without pressing any other buttons.
Note
When you listen to a sound source other
than the tuner, you can select the tuner by
pressing TUNER/BAND (Automatic
Source Selection).
AM