Adjustment
25
Selecting the ICU
When you use multiple JTC-P200 ICUs on the screen site, select the ICU
to be operated.
Notes
• You do not need to select the ICU if only one JTC-P200 ICU is used on
the screen site.
• To operate multiple ICUs, the ID numbers of the ICUs should be
registered beforehand.
For registering the ID numbers, see page 23.
1
Establish the communication with the ICU controller (page 21) and
display the MAIN MENU.
2
Press the
v
or
V
button to select OTHER CONTROL, and press the
ENTER button.
The OTHER CONTROL menu appears.
S W I T C H E R C O N T R O L
S I G N A L C O N T R O L
G E O M E T R Y C O N T R O L
M O N I T O R C O N T R O L
S C R E E N C O N T R O L
S C R E E N U N I T C O N T R O L
O T H E R C O N T R O L
* * * * * * M A I N M E N U * * * * * *
S C R E E N I N F O
P R O D U C T I N F O
P R O C E S S O R R E G I S T
P R O C E S S O R S E L E C T
* * * * O T H E R C O N T R O L * * * *
3
Press the
v
or
V
button to select PROCESSOR SELECT, and press the
ENTER button.
The PROCESSOR SELECT menu appears.
P R O C E S S O R N o . 1
P R O C E S S O R N o . 2
P R O C E S S O R N o . 3
P R O C E S S O R N o . 4
* * P R O C E S S O R S E L E C T * *
4
Press the
v
or
V
button to select the ICU you want to operate.
5
Press the ENTER button.
The communication with the selected ICU is enabled, and
“SELECTED!” appears.
Note
If the communication with the selected ICU failed when you pressed the
ENTER button in step
5
, “SELECTION ERROR!” appears. Check the
connections and perform “Registering the ID number of the ICU” (page
23) again.
Before Adjustment
