Ad
minis
tra
ting t
he Camer
a
Action input Menu — Setting the Sensor input/Camera tampering detection/Motion detection
53
Notes
• Before actual use, perform an operation test and
confirm that the face detection function works
correctly.
• An inactive area cannot be specified.
• A horizontal face (leaning too far sideways) cannot be
detected.
• Vertexes cannot be added or deleted. They are for
specifying a rectangular area only.
• When privacy masking is used, the face detection
function is not available for the mask areas.
Detection area
Specify the effective scope of face detection. You can set
the area in the same way as the detection area setting in
VMD settings. (page 47)
A maximum of ten detection areas can be set. Similar to
the detection area setting in VMD settings, a trigger area
and vertexes can also be moved.
Note
When the output mode is set to
HDMI
,
4K 25fps
, or
4K
30fps
, this function cannot be set.
Detection sensitivity
Set the sensitivity of face detection. A value from
0
to
64
can be specified. Select low values to limit detection to
the human face, or high values to also detect subjects
that are similar the human face. This makes detection
easier when the subject is far from the camera.
Clicking
Return to the default
changes the value to the
default value.
Detection size
Specify the minimum and maximum size of face
detection. You can specify the size by specifying values
or by dragging vertexes to choose the area.
OK/Cancel
Click
OK
to finalize any changes made to the settings
and send them to the camera.
If you click
Cancel
, changes made to the settings will be
discarded and the screen will be reloaded with the
current camera settings.
Network disconnection Tab
— Monitoring the connection of a
specified IP address
Monitored IP address
Set the specific IP address of which the network
connection status is to be monitored.
