Sony IPELA SNC-DM110, Service Manual

Page: 36 / 80

4-6
SNC-DS10/DM110
4-5. Image is not displayed from the analog video output
Image is not displayed
from the analog video output.
No
No
Yes
Yes
Yes
Yes
Yes
No
No
Set to “NTSC
+
IP mode” or “PAL
+
IP mode” using the
Video Out selection switch or [System]-[Installation]-video
output mode in the Setup menu.
Failure of IC202 and peripheral
circuit on the SY board.
Replace the defective parts.
Failure of IC203 and peripheral
circuit on the SY board.
Replace the defective parts.
Failure of CN810, R218,
FL801 or D817 on the SY board.
Replace the defective parts.
Is the power LED lit?
No
Yes
Does the video signal exist
between pin 4 and pin 5
of IC203 on the SY board?
No
Replace the connecting
cord (for video).
Refer to “4-1. Power LED is not lit”.
Refer to “4-3. Image is not displayed on the PC viewer”.
Is the setting set to the
video output (NTSC/PAL)?
Is the IP image displayed?
Is the video signal output
from the pin plug?
Does the video signal exist
between pin 1 and pin 2
of CN810 on the SY board?
*
1: For details of the setting procedure, refer to “Installation Manual” and “User’s Guide”.
*
1