7
Chapter 7 Location and Function of Parts and Controls
82
HDC-900/950/930 Series Product Information Manual
7-2.
HDC-950/930, HD Color Video Camera
7-2-1
Front Right Side
a
INCOM (intercom 1) button
The intercom 1 microphone is turned ON while this
button is pressed.
b
RET 1 (return video 1) button
The return video 1 signal from the camera control unit
is monitored on the viewfinder screen while this button
is pressed. It is the same function as with the RET 1
buttons on the sides.
c
Y/RGB switch
Select the video signal output for the VF and TEST OUT
connectors.
Y
: Output is the Y signal (this is the power-on default).
RGB
: Output is the component video signal(s)
selected by the R/G/B switch.
d
R/G/B (red/green/blue) switch
When the Y/RGB switch is set to RGB, select the
component video signal(s) to be provided as output to
the VF and TEST OUT connectors.
e
ASSINABLE switch
You can assign a function using the OPERATION
menu.
f
FILTER (internal filter selection) control
Used to select an internal filter appropriate for the light
source illuminating the subject.
g
AUTO W/B BAL (white and black balance
automatic adjustment) switch1)
Used to automatically adjust white and black balance.
WHT
: Automatically adjust white balance.
BLK
: Automatically adjust black balance.
h
CAMERA/VTR (switch1)
Used to select control signals sent to a VTR connected
to the camera. The operation of the VTR at the start of
recording for each setting is shown in the table below.
i
GAIN (switch1)
Used to select the gain of the video amplifier based on
lighting conditions. The gain values for the L, M, and H
settings may be set using the menus. When shipped
qf
MENU SEL knob/
ENTER button
1
INCOM button
2
RET 1 button
3
Y/RGB switch
4
R/G/B switch
5
ASSINABLE switch
6
FILTER control
7
AUTO W/B BAL switch
8
CAMERA/VTR switch
9
GAIN switch
q;
OUTPUT/AUTO
KNEE switch
qa
WHITE BAL switch
qs
DISPLAY switch
qd
CANCEL/STATUS switch
ND filter
Color temperature
conversion filter
1
Clear
A
Cross filter
2
1/4ND
B
3200K
3
1/8ND
C
4200K
4
1/16ND
D
6300K
5
1/64ND
E
8400K
CAMERA
VTR
Function
OFF
SAVE
Turn off the camera power.
ON
SAVE
Camera power is on. When
the VTR START button is
pressed, recording will begin
after a few seconds.
ON
STBY
Turn on the camera power.
When the VTR START button
is pressed, recording will
begin immediately.
Summary of Contents for HDC-900 Series
