6-27
DCR-DVD100/DVD100E
1-4.
COLOR ELECTRONIC VIEWFINDER SYSTEM
ADJUSTMENT
Note1:
When replacing the LCD unit, be careful to prevent damages
caused by static electricity.
Note2:
Before performing the adjustments, check the data of page: 0,
address: 10 is “00”. If not, set data: 00 to this address.
Note3:
As the PANEL CLOSE switch is attached to the cabinet (R), this
cabinet must be attached when performing adjustments.
If you perform the adjustments with cabinet (R) removed, set the
following data.
1) Select page: 3, address: 00, and set data: 00.
2) Select page: 3, address: 02, set data: 02, and press PAUSE button.
Reset the data after completing adjustment.
1) Select page: 3, address: 00, and set data: 00.
2) Select page: 3, address: 02, set data: 00, and press PAUSE button.
Note4:
NTSC model: DCR-DVD100
PAL model: DCR-DVD100E
Switch setting:
LCD panel .................................................................... Closed
[Adjusting connector]
Most of the measuring points for adjusting the viewfinder system
are concentrated in CN1003 of VC-307 board.
Connect the Measuring Instruments via the CPC-8 jig (J-6082-388-
A).
The following table shows the Pin No. and signal name of CN1003.
Pin No.
Fig. 6-1-14.
Table 6-1-10.
Pin No.
1
3
5
7
9
11
13
15
17
19
Signal Name
GND
PANEL VG
XHD/PSIG
EVF VCO
D 3.1V
MS XIN
MS BS
MS SCLK
C PIO5
S TXD
Pin No.
2
4
6
8
10
12
14
16
18
20
Signal Name
GND
H START
EVF VG
EVF BL
LANC SIG
MS DIO
MS VCC ON
ACCESS LED
C PIO4
S RXD
COVER
COVER
20
2
19
1
Remove the CPC lid (bottom).