SEL85F14GM (FE 1.4 / 85 GM) (FE 85mm F1.4 GM)
4-11
5. The installer start up screen appears, then click the [Next] button to start the installation.
6. The following screen appears when the installation is complete, then click the [Close] button.
7. Create a shortcut icon of the E-Mount Lens Adjustment (Adjustment Application for Service) on the desk top.
4-6-2. Precautions
If the “PUSH ENTER” does not disappear even after pressing the ENTER key, press it again.
Do not touch the focus ring when performing operations on lens side, as the focus is on
∞
status during adjustment.
4-6-3. Method for Starting and Finishing
Method for Starting the E-Mount Lens Adjustment
• After replacing the Optical Block For Service, click the [Service Flag OFF (S)] button to release the specified flag before using the E-Mount Lens
1-5. NOTE ON REPLACEMENT OF OPTICAL BLOCK FOR SERVICE
• When replacing the Main Board, if you can read the adjustment data, click the [READ] and select the [Adjustment Data Backup], Please read the
1-6. NOTE ON REPLACEMENT OF MAIN BOARD
• Make sure to disconnect the AC adaptor after finishing the adjustment (including the case when stops due to an error).
• SeusEX will start when the E-Mount Lens Adjustment is started.
1. Turn on the power of camera.
2. Start the E-Mount Lens Adjustment.
3. The camera selection window opens, and select “ILCE-5000”.
Note:
Only ILCE-5000 cameras are available for the adjustment of the unit.
4. Click the [Connect] button and check that the connection status becomes “Connect”.
