1-42
DXC-D35/D35WS(UC)
DXC-D35P/D35WSP(CE) V1
82
Chapter 5
Adjustments and Settings
Chapter 5 Adjustments and Settings
If the ATW function does not operate correctly
A warning massage appears in the viewfinder as
shown in the table below.
Message
Meaning and corrections to be made
If the FILTER control is in position 2, 3 or
4, change it to position 1, then retry the
ATW operation.
:C.TEMP.LOW
If the FILTER control is in position 1,
change it to position 2, 3 or 4, then retry
the ATW operation.
:C.TEMP.HIGH
White Balance Adjustment
Chapter 5
Adjustments and Settings
83
Chapter 5 Adjustments and Settings
Note
When using a camera control unit or remote control
unit, if the W/B BALANCE switch of the control unit
is set to MANUAL, it is not possible to carry out black
balance adjustment on the camera.
If black balance adjustment cannot be
completed automatically
The warning message “AUTO BLACK -NG-” appears
in the viewfinder.
Make the necessary corrections, then carry out the
process again.
Warning messages for black balance adjustment
Message
Meaning and corrections to be made
AUTO BLACK
-NG-
:
IRIS
NOT CLOSED
TRY AGAIN
The lens iris did not close fully.
Check whether the lens cable is
connected properly, and whether there is
a fault in the lens. If a second attempt to
carry out the adjustment fails, consult
your Sony dealer.
AUTO BLACK
-NG-
:
??
TRY AGAIN
The iris opened during adjustment or
there is a hardware error.
Close the iris and try again. If this fails,
consult your Sony dealer.
Black Balance Adjustment
2
1
BARS
The camera is outputting a color bar
signal.
Move the OUTPUT/DL/DCC+ switch to
one of the CAM positions.
Correct adjustment of the black balance is important
for optimum operation of a video camera. It is
necessary when using the camera for the first time or
after a significant period out of use, and also when
there has been a sudden change in temperature.
The adjustment value is saved in memory, and
readjustment is not normally necessary after powering
the camera off or simply when lighting conditions
change.
1
Move the POWER switch to the ON SAVE
position, and check that the OUTPUT/DL/DCC+
switch is in one of the CAM positions.
2
Push the WHT/BLK switch in the BLK direction
and release.
The lens iris closes, and black balance adjustment
is carried out.
During the adjustment the legend “AUTO BLACK
-OP-” appears in the viewfinder.
AUTO BLACK
-OP-
After a few seconds the adjustment is complete,
and the legend in the viewfinder changes to
“AUTO BLACK -OK-”.
