1-32
DXC-D35/D35WS(UC)
DXC-D35P/D35WSP(CE) V1
62
Chapter 4
Viewfinder Screen Indications and Menus
Chapter 4 Viewfinder Screen Indications and Menus
4
Press the UP/ON button to select the required
character.
Each time you press the UP/ON button, the
character cycles through the following sequence.
ABCDEFGHIJKLMNOPQRSTUVWXYZ?;x/0123456789:
-
.,
To reverse the character sequence
With the UP/ON button held down, press the
DOWN/OFF button.
5
Press the DOWN/OFF button to confirm the
character selection.
The cursor advances to the next character position.
To change a character after confirming it
Return to step
3
, and input the character again.
6
Repeat steps
4
and
5
until the title is complete.
7
When the title is complete, press the MENU/
STATUS switch as necessary to return to the
normal viewfinder indications.
The title created is retained, even when you power
the camera off.
To record a title (page 8)
1
Press the MENU/STATUS switch as necessary to
access basic menu page 8 (title display).
2
Press the UP/ON button once.
The title is superimposed to the picture displayed
on the viewfinder screen.
3
Start shooting.
4
To stop the title recording, press the MENU/
STATUS switch to clear the title display.
Note on using the CCU-M5/M5P Camera Control Unit
When the CCU-M5/M5P has a function switch setting
of “TITLE ON”, the title display takes precedence, and
the status display (see page 57) do not appear in the
normal incidations. However, when you press the
MENU/STATUS switch up, for as long as you hold it
up the status indications appear in place of the title.
When “CHECK DIAG” is displayed
The “CHECK DIAG” indication appears in the status
display area whenever the camcorder’s automatic self
diagnostic function detects an abnormality. Access
this page and perform error checking. (This page is
displayed as basic menu page 1.)
“CHECK DIAG” will also be displayed if there is a
problem on the sync signal input to the GEN LOCK
IN connector. Input a proper sync signal and then
perform error checking.
To perform error checking
Press the UP/ON button.
The error checking performs on the digital signal
processing (DSP) and memory circuits and the results
are displayed.
When no error is detected, “OK” appears.
Viewfinder Basic Menu
(Space)
Chapter 4 Viewfinder Screen Indications and Menus
63
Chapter 4 Viewfinder Screen Indications and Menus
Example: If an abnormality is detected in the DSP
circuit.
DIAGNOSIS
DSP : ERROR
MEMORY: OK
DIAG ERROR
The error message “DIAG ERROR” appears when the
normal indications are displayed. If this message
appears, contact your Sony dealer.
