Sony DXC-390, Service Manual, Page: 41 / 110

2-1 (E)
DXC-390/390P
Section 2
Service Overviw
2-1. Board location
2-2. Removal of cabinet
1. Remove the seven screws (P2
x
3) and then remove
the upper case.
2. Remove the two screws (P2
x
3) and then remove the
stay.
3. Remove the two screws (P2
x
3) and then remove the
rear panel.
Remove the flat cable from the rear panel.
4. Loosen the three screws (B3
x
8) and then remove the
tripod adaptor. (These screws cannot be removed
because of stoppers.)
5. Remove the CCD block, referring to the Section2-3.
“Removal of CCD block”.
6. Remove the flat cable from the SG-265/265P board.
7. Remove the four screws (P2 x 3) on the MB-875/875P
board and then remove the lower case.
n
Do not damage the flat cable.
DP-313/313P
board
VA-193/193P
board
EN-142/142P
board
SG-265/265P
board
CN-1938 board
MB-875/875P
board
PA-236 board
* 1
* 1
P2 x 3
Lower case
Upper case
Stay
CCD block
VA-193/193P
board
SG-265/265P
board
P2 x 3
B3 x 8
Rear panel
Flat cable
P2
x
3
P2
x
3
P2 x 3
P2 x 3
Tripod adaptor
MB-875/875P board
* 2
* 2
* 3
*
3
* 4
* 4
P2
x
3
Flat cable
B3 x 8