Sony DXC-390, Service Manual, Page: 35 / 110

1-29 (E)
DXC-390/390P
56
(GB) Chapter 3 Installation and Connections
Chapter 3
Connections for Shooting Using a Flash
Note
When connecting a flash unit, set TRIGGER to ON in the
GENERAL menu (page 27) and D-SUB SYNC to WEN in
the SYSTEM menu (page 28).
VIDEO OUT
DC IN/VBS
REMOTE
LENS
TRIG IN
MENU LOCK
OFF ON
RGB/SYNC
1
2
Synchronization cable
Video input
connector
Video monitor, VCR, etc.
Video output
connector
Image processor
Flash
Slave unit
DXC-390/
390P
TRIG IN
Remote connector
Video input
connector
DC IN/
VBS
RGB/SYNC
CCMC-9DSMN/CCMC-9DS/
CCXC-9DB camera cable
CMA-D2/D2MD/D2CE/
D2MDCE camera adaptor
Set the MODE
selector to the “1”
position.
CAMERA
(4-pin or 12-pin)
CCDC-5/10/25/50A/100A cable
or
CCMC-12P02/05/10/25 cable
Power cord
Chapter 4 Appendix
57
(GB)
Chapter 4
Precautions
Chapter
4
Appendix
Operating or storage location
Operating or storing the camera in the following locations
may cause damage to the camera:
• Extremely hot or cold places (Operating temperature: –5°C
to +45°C [23°F to 113°F])
• Exposed in direct sunlight for a long time, or close to
heating equipment (e.g., near heaters)
• Close to sources of strong magnetism
• Close to sources of powerful electromagnetic radiation,
such as radios or TV transmitters
• Locations subject to strong vibration or shock
Ventilation
To prevent heat buildup, do not block air circulation around
the camera.
Transportation
When transporting the camera, repack it as originally packed
at the factory or in materials equal in quality.
Cleaning
• Use a blower to remove dust from the lens or optical filter.
• Use a soft, dry cloth to clean the external surfaces of the
camera. Stubborn stains can be removed using a soft cloth
dampened with a small quantity of detergent solution, then
wipe dry.
• Do not use volatile solvents such as alcohol, benzene or
thinners as they may damage the surface finishes.