Sony DXC-390, Service Manual, Page: 29 / 110

1-23 (E)
DXC-390/390P
44
(GB) Chapter 3 Installation and Connections
Chapter 3
Installation
Mounting the VCL-614WEA Zoom Lens
1
Remove the mount caps of the camera and lens.
2
Align the threaded portion of the lens mount with that of
the camera mount, and turn the mount lock ring
clockwise as far as it goes to fix the lens to the camera.
3
Connect the lens control cable to the LENS connector
on the camera.
To adjust the position of the lens
After tightening the mount lock ring, loosen it by turning it
counterclockwise by approximately 90º. Then rotate the lens
to adjust the position, and tighten the mount lock ring
securely.
Mounting C-mount lens other than the VCL-
610WEA and VCL-614WEA other
Also refer to the instruction manual supplied with the lens.
1
Remove the mount caps of the camera and lens.
2
Align the threaded portion of the lens mount with that of
the camera mount, and slowly rotate the lens clockwise
to fit to the camera.
To adjust the position of the lens
Refer to the instruction manual supplied with the lens.
Lens control cable
1
1
3
2
2
Chapter 3 Installation and Connections
45
(GB)
Chapter 3
Attaching the supplied tripod adaptor
Following is an example of attaching the tripod adaptor to
the bottom panel of the camera. You can also attach the
tripod adaptor to the top panel of the camera.
Mounting to a Wall or Ceiling
Attach the camera with the tripod adaptor to the mounting
bracket or suspension bracket using the appropriate screws
(U1/4”, 20 UNC) that fit the tripod holes of the adaptor.
Mounting a Microscope Adaptor
To attach the camera to a microscope, an operating
microscope, etc., it is necessary to mount an appropriate
adaptor. The method for mounting the adaptor is the same as
for the lens.
For details, refer to the instruction manual for each
adaptor.
Mounting on a Tripod
Install the supplied tripod adaptor using the three screw
holes (M3) on the top or bottom panel. Then attach the
tripod to the adaptor using the following mounting screws:
U1/4”, 20 UNC
4
= 4.5 mm ± 0.2 mm (ISO standard)
(Continued)
M3 screws
Tripod adaptor
e.g. Attaching on the bottom panel