Chapter 2 Playback
Chapter 2
Playback
21
Set Points A and B for Repeat Playback
You can set the repeat top point (point A) and repeat end point (point B)
by using the current tape position or inputting time code values.
Set the current tape position as point A or B
While holding down the SET (YES)
[MARK]
button on the menu control
panel, press the
¿
[A]
or
[B]
÷
button. The time code value of the current
tape position is set as point A or B for repeat playback, and a message “A
set” or “B set” flashes momentarily in the time counter display.
Once set, the point A or B time code value is held in the unit’s non-volatile
memory until changed. It is not lost when the unit is powered off.
Note
You cannot use a CNT value to set point A or B even when CNT
indication mode is selected (the COUNTER indicator lit), but you can only
use a time code value for this purpose.
To check the point A or B time code value
Press the
¿
[A]
or
[B]
÷
button on the menu control panel. While the
button is held down, the point A or B time code value is displayed on the
monitor and in the time counter display.
If you hold down both the
¿
[A]
and
[B]
÷
buttons, the value shown is
the point B time code value minus the point A time code value. If the
point A time code value is greater than the point B time code value, a
minus sign (–) is shown before the value.
MENU
RESET(NO)
SET(YES)
A
B
MARK
Buttons used for setting
the current tape position
as Point B
Buttons used for
setting the current
tape position as
Point A