Sony DNW-75, Operation Manual

Page: 63 / 120

Chapter 5
Editing
Chapter 5 Editing
5-5
When the audio IN point is not set for insert
editing of audio only
As long as the audio OUT point is set, the VTR is
ready for preview or editing. If the audio IN point has
not been set, the current tape position is automatically
used as the audio IN point.
Using a VTR without a split editing function as
the player
If it is not possible to set separate audio and video edit
points on the VTR you are using as the player, by
setting the audio IN and OUT points on the recorder
(this unit), then setting three video edit points, split
editing is possible.
To display the time value for an edit point
You can display the time value for an edit point in the
control panel display section (see page 2-9).
The IN point appears in time data display area 1, and
the OUT point in time data display area 2.
1
Press the RECORDER button or PLAYER button
to select the VTR on which you wish to check the
edit point.
The button you have pressed lights.
2
Hold down the IN button or OUT button according
to the edit point you wish to check.
While you hold down the button, the IN indicator
or OUT indicator of time data display area 1 or 2
lights, and the time value of the edit point is
displayed.
To display the duration of an edit
You can display the duration between two edit points
in the following three cases, in the control panel
display section (see page 2-9).
• When both the IN point and OUT point are set: the
duration of the segment between the two points
• When only one of the IN point and OUT point is set:
the duration of the segment between the point which
is set and the current tape position
• When neither of the IN point and OUT point is set:
the duration of the previous editing segment
The duration is displayed across time data display
areas 1 and 2, thus: “DURATION 00:01:10:00”.
To display a duration, use the following procedure.
1
Press the RECORDER button or PLAYER button
to select the VTR on which you wish to check the
duration.
The button you have pressed lights.
2
Hold down both the IN button and OUT button.
While you hold down the buttons, the duration is
displayed across time data display areas 1 and 2.
Time data display area 1
2 1
9 ) 0 6 p
%
Time data display area 2