![background image](http://html.mh-extra.com/html/sony/dhc-md5/dhc-md5_operating-instructions-manual_420517040.webp)
DHCMD5 3-858-047-12.EN (1)
40
5
Set the time to start recording.
Turn MULTI JOG to set the hour, then
press ENTER/YES.
The minute indication starts flashing.
Turn MULTI JOG to set the minute, then
press ENTER/YES.
The hour indication flashes again.
6
Set the time to stop recording
following the above procedure.
7
Turn MULTI JOG and select
“TUNER to MD.”
8
Press ENTER/YES.
The start time, followed by the stop time,
preset number and the recording source
appears, then the original display
appears.
9
Insert a recordable MD.
10
Turn off the power.
Timer-recording radio programmes
(contined)
To check the setting
Press TIMER SELECT repeatedly until “REC
TIMER” appears. The start time, followed by
the stop time and the preset number appears,
then the original display appears. To change
the setting, start again from step 1.
To cancel the timer operation
Press TIMER SELECT repeatedly until
“TIMER OFF” appears.
Tip
When you connect a tape deck as the TC-TX5
equipped with an AU BUS connector to the system,
you can activate the timer-recording with the tape
deck.
Notes
• Do not operate the system from the time the
power turns on until the recording starts (about 20
seconds).
• When you use the blank MD to record, the first 15
seconds will not be recorded.
• If the power is on at the preset time, the recording
will not be made.
• The volume is reduced to minimum during
recording.