Sony DCR-PC350 - Digital Handycam Camcorder, Service Manual

Page: 173 / 218

— 19 —
DV MECHANICAL ADJUSTMENT MANUAL VII
3-8. Retainer Plate
1. Removal procedure
1) Remove LED
1
from the retainer plate.
2) Remove the two screws (special head screw M1.4
×
2.0)
2
.
3) Release the three claws
B
,
C
and
D
, and remove the retainer
plate
3
in the direction of the arrow mark
E
.
4) Release the claw A and remove the reel lock release 4 .
2. Attachment procedure
1) Install the reel lock release
4
.
2) Place the retainer plate
3
on top of the LS chassis block assy
and engage the three claws in the order starting from
D
,
C
and
B
.
3) Install the two screws (special head screw M1.4
×
2.0) 2 in
the order starting from
F
then
G
.
Tightening torque: 0.059
±
0.01N•m (0.6
±
0.1kgf•cm)
4) Install LED
1
to the retainer plate.
1
LED
4
Reel lock release
3
Retainer plate
Claw
C
Claw
A
Claw
D
F
G
E
Claw
B
2
Two screws
(M1.4
×
2.0)
REEL LOCK RELEASE
•
The reel lock release should not be re-used.
•
The retainer plate must not have any deformation.
•
The reel lock release should be fully installed.
(Should not be left in the half-installed state.)
RETAINER PLATE
•
All claws must be fully engaged.
(Caution : No claws should be left disengaged.)
•
The flexible board should not be pinched by anything.
•
The retainer plate must not touch with the MIC terminal.
Key Points
in Re-assembling Key Points
in Re-assembling