DSC-WX50_L2
1-13
A
qs
qd
qf
qg
qh
qj
qk
Shield Ring (D)
1 Group Assy
Frame Block Assy (1430A)
Tube Lubricating
Block Assy
Shield Ring (AB)
Cam Tube
Block Assy
Barrier Assy
Claws
Claws
Ornamental
Ring A
Bond
Tweezers
Group 1 Frame
Group 1 Lens
Frame Assy
Solvent
Objective Side View
Remove the Shield Ring (D) and remove the Frame Block Assy (1430A).
Remove the 1 Group Assy.
Remove the Tube Lubricating Block Assy and the Shield Ring (AB) from the Cam Tube Block Assy.
Apply alcohol to two gaps A of the Ornamental Ring A with tweezers or a fine-tipped stick as shown below.
Turn the Ornamental Ring
A
clockwise and counterclockwise to detach it.
Remove bond at two locations shown in the figure below and turn the Group 1 Lens Frame Assy.
Remove the Group 1 Lens Frame Assy from the Group 1 Frame.
Installation
1
2
3
Bond
Round mark
Round marks
4
5
6
7
Barrier Tape
Dent
Hole
Barrier
Lever
Barrier Assy
Claws
Claws
Barrier Assy
Barrier Tape
Barrier Tape
Ornamental
Ring A
Group 1 Frame
Group 1 Lens
Frame Assy
Barrier Tapes
Objective Side View
Objective Side View
Objective Side View
Install the Group 1 Lens Frame Assy to the Group 1 Frame.
Turn the Group 1 Lens Frame Assy so that the round mark comes to the position shown in the figure below.
Apply bond to the two points shown in the figure below.
Note:
Use Super X bond or equivalent.
Fit the four claws while inserting the Barrier Lever into the hole and attach the Barrier Assy.
Affix two Barrier Tapes to the Barrier Assy so that the end of each Barrier Tape touches the dent.
Note:
The Barrier Tapes must not be wrinkled.
Peel off the release papers of the Barrier Tapes.
Install the Ornamental Ring A and press it lightly.
