![background image](http://html.mh-extra.com/html/sony/cmt-j3md/cmt-j3md_operating-instructions-manual_420385070.webp)
70
Troubleshooting (continued)
Recording or editing was done, but the
TOC is not updated.
• MD recording and editing contents are
recorded to the MD when the MD is removed,
so make sure you remove the MD after
recording or editing (see pages 32 and 43).
Recording is not possible.
• Remove the MD and slide the tab to close the
slot (see page 32).
• Connect the optional A/V component
properly (see page 65).
• Switch to another sound source.
• Replace the MD with a recordable MD, or use
the Erase Function to erase unnecessary tracks
(see pages 45 – 48).
• Start recording over from the beginning.
The sound from an MD you recorded is
too low (or too high).
• Readjust the recording level (see page 40).
Tape Deck
The tape does not record.
• No cassette is inserted. Insert a cassette.
• The tab has been removed from the cassette.
Cover the broken tab with adhesive tape (see
page 67).
• The tape has wound to the end.
The tape does not record or play, or there
is a decrease in sound level.
• The heads are dirty. Clean them.
• The record/playback heads are magnetised.
Demagnetise them (see page 67).
The tape does not erase completely.
• The record/playback heads are magnetised.
Demagnetise them (see page 67).
There is excessive wow or flutter, or the
sound drops out.
• The capstans in the tape deck are dirty. Clean
them using a cleaning cassette.
Noise increases or the high frequencies
are erased.
• The record/playback heads are magnetised.
Demagnetise them (see page 67).
Play does not start from the first track.
• Press PLAY MODE repeatedly until “PGM”
or “SHUFFLE” disappears to return to normal
play.
“—OVER—” appears.
• Keep pressing
lm
to return to the
desired playing position.
MD Deck
An MD cannot be inserted.
• Insert the MD with the arrow side up and the
arrow pointing toward the deck.
The controls do not work.
• Replace the MD with a new one.
• Retry the operations after “TOC” or
“STANDBY” turns off.
Play does not start.
• Replace the MD.
• Insert the MD and leave the system turned on
for a few hours until the moisture evaporates.
• Press MD
HS
to start play.
The sound skips.
• Replace the MD.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the
system, or placing them on separate stands.
When you listen to a track with bass sounds at
high volume, the speaker vibration may cause
the sound to skip.
• Insert the disc and wait for 10 to 20 minutes
with the system turned on.
Play does not start from the first track.
• Press PLAY MODE repeatedly until “PGM”
or “SHUFFLE” disappears to return to normal
play.
“—OVER—” appears.
• Keep pressing
lm
to return to the
desired playing position.
“OVER” lights red during recording.
• Adjust the recording level lower (see
page 40).
Summary of Contents for CMT-J3MD
Page 79: ...Additional Information 79 ...