8
Step 3: Presetting radio stations
(continued)
To stop scanning
Press TUNING MODE.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
“MANUAL” appears in step 2, then press
or – repeatedly to tune in the station
manually.
To set another station to the
exist preset number
Start over from step 1. After step 5, press
.
or
>
on the remote to select the preset number
you want to store the other station.
To erase a preset station
1
Press MENU/NO on the remote.
2
Press
.
or
>
repeatedly until “P.Erase ?”
appears.
Select “P.All Erase ?” when you want to erase
all the preset stations.
3
Press ENTER/YES on the remote.
4
Press
.
or
>
repeatedly to select the
preset number you want to erase.
5
Press ENTER/YES.
“Complete !!” appears.
When you erase a preset number, the preset
number decreases by one and all preset numbers
following the erased one are renumbered.
To change the AM tuning interval
(except for the European model)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the system. While holding down the TUNING
MODE button, turn the system back on. When you
change the interval, all the AM preset stations are
erased. To reset the interval, repeat the same
procedure.
Tips
• The preset stations are retained for about a day even
if you disconnect the mains lead or if a power failure
occurs.
• You can label the preset stations (see page 59).
• When an FM programme has static noise,
press STEREO/MONO until “MONO” appears.
There will be no stereo effect, but the reception will
improve. Press the button again to restore the stereo
effect.
Summary of Contents for CMT-J3MD
Page 79: ...Additional Information 79 ...