![background image](http://html.mh-extra.com/html/sony/cmt-cp505md/cmt-cp505md_operating-instructions-manual_420294023.webp)
23
GB
MD – Recording
CMT-CP505MD 4-241-515-11(1) GB
Marking track numbers
• Automatically during recording (Level
Synchro Recording)
Track numbers are automatically marked as on
the original source during recording from this
system’s CD player or components connected
to DIGITAL OPTICAL IN jack. However,
track numbers are not marked depending on the
track (page 63).
Use the Level Synchro Recording Function to
automatically mark track numbers during
recording from this system’s tuner or
components connected to the ANALOG IN
jacks. However, track numbers are not marked
automatically if the source sound to be
recorded is noisy (e.g., tapes or radio
programs).
Note
When recording a CD, track numbers are marked
where you paused recording. In addition, the tracks
might be recorded as the same single track with a
single track number when the same single track of the
same CD is recorded repeatedly.
• At any point during recording (Track
Mark)
You can mark track numbers during manual
recording of any source.
• After recording
Use the Divide Function (page 36).
This function is convenient when the source is
tape or radio programs and the track numbers
are not marked automatically.
Recording tips
Adding “LP:” to a track name
during MDLP recording
You can add “LP:” at the beginning of the track
title which appears when you try to play the
track on a system that does not support MDLP
mode. This convenient function lets you know
at a glance that the track is recorded in MDLP
mode and cannot be played back.
It does not appear when the system supports
MDLP mode.
1
Press FUNCTION repeatedly to switch the
function to MD.
2
Press MENU/NO on the remote.
3
Press
.
or
>
on the remote
repeatedly until “Setup?” appears, then
press ENTER/YES on the remote.
4
Press
.
or
>
on the remote
repeatedly until “LP Stamp Off ” (or “LP
Stamp On”) appears, then press ENTER/
YES on the remote.
5
Press
.
or
>
on the remote
repeatedly to select the setting, then press
ENTER/YES on the remote.
To
Select
Add “LP:”
Cancel adding “LP:”
6
Press MENU/NO on the remote.
Notes
When set to “On”, “LP:” is recorded as the track title,
so the number of characters that can be input to an
MD is reduced. In addition, if you divide an “LP:”
track using the Divide Function, “LP:” is also added
to the latter track.
LP Stamp On
(factory setting)
LP Stamp Off
continued