35
15. After adjusting, apply screwlock.
16. By pressing the DISC SKIP + and DISC SKIP - button, check
the loading in and out operations can be performed properly.
17. Remove the disc and press the
U
button to turn OFF the power.
18. Set the DIP switch as below and attach the shield.
10. After adjusting, apply screwlock.
11. Continue pressing the DISC SKIP – button. After loading out,
continue pressing the DISC SKIP + button until loading in
again.
12. Check that the disc is at the position adjusted to in step 7.
13. Continue pressing the DISC SKIP + button until loading end.
14. Visually check the chucking pulley, and adjust the adjusting
screw B shown in the figure so that the positional relation of the
holder (magnet) and chucking pulley satisfies the specified val-
ues. (Fig. 4, Fig. 5).
A
B
Holder
Chucking pulley
No clearance
Apply screwlock
Adjusting screw B
Fig. 6
Fig. 7
Specified value: Clearance A = Clearance B
SCSI TERM
MODE
ID SELECT
4 2 1 4 2 1
DRIVE
CHANGER
ON
PARITY
Attach the shield.
19. Attach the plate removed in step 1.
