14
Preparation and Setting
When the PMW-500/350/320 Solid-State Memory Camcorder is connected, the
microphone input settings for the intercom headset will be fixed at the following
(factory default) values:
Dynamic / -60dB / Unbalanced
For information on connection to an intercom system and configuration of the
settings, contact your Sony dealer.
Starting the System
1
Attach the adaptor to the camera/camcorder, then connect the adaptor to the CCU
using a triax cable.
2
Set the POWER switch of the adaptor and camera/camcorder to ON, then set the
POWER switch of the CCU to ON. Power will be supplied to the adaptor from the
CCU and the adaptor turns on. The adaptor then supplies power to the camera/
camcorder, which turns on.
While the system is starting up, the POWER lamp (green) blinks at 0.5 Hz. When the
communication for certification between the adaptor and camera/camcorder
completes, the POWER lamp (green) lights.
When the POWER switch of the connected camera/camcorder is set to OFF, or when
the camera/camcorder does not start normally, the POWER lamp (green) keeps
blinking at 0.5 Hz.
Setting the System Format
To record/output with the system, it is necessary to set the video format for the
camera/camcorder, adaptor and CCU.
The adaptor supports the following video formats.
• 1920×1080/59.94i
• 1280×720/59.94P
• 1920×1080/50i
• 1280×720/50P
The video format setting of the adaptor is synchronized with that of the CCU.
Note
Note
Summary of Contents for CA-TX70
Page 21: ...Sony Corporation ...
