3.4
Slate/Com Microphone Control
The SX-RC8+ includes a microphone preamplifier with automatic gain control and Low
Frequency Cut filter. User can choose between the front panel mic or an external
headset connected to the Headset/Headphones 3.5mm jack.
The SX-RC8+ configuration is integrated
into the SX-R4+ touch interface.
The configuration panel is located on
SETUP/SYSTEM/MISC/RC8+
•
MIC SOURCE are two mutually
exclusive buttons where the
microphone source is selected
•
LIMITER GAIN and
THRESHOLD allow user to
control the automatic gain control
•
POT POS NOISE REDUC.
should be enabled in noisy
environment where the SX-R4+
detects faulty faders movements.
Any push-button of the SX-R4+ or SX-
RC8+ can be used to control the
slate/com.
Enter the menu SETUP/SYSTEM/PUSH
BUTTONS to modify push-buttons
assignation.
The label “SX-RC8+ MIC” correspond to
the slate/com microphone enable action.
3.5
Hirose Power Distribution
The power distributor on the left panel is fully independent and does not need any
power for the SX-RC8+ to operate. There are 5x Hirose 4 connectors connected as
following:
POWER
SMBUS
Note: there is no connection between the SX-R4+ power for the SX-RC8+ and that
power distribution.
The optional solder jumpers on pins 2 & 3 are dedicated for a System Management
Bus (SMBUS). By default, these jumpers are open.
SX-RC8+ User Manual
6/8
