2
Safety
Intended use
Any use of the system other than the intended
use can cause serious injury, death, and damage to
the product or other assets.
• The storage system must only be used to store
electrical power.
• The storage system must only be used with the
battery modules provided.
• The storage system is intended for indoor use
only.
• The intended use includes knowledge
and application of the information in this
installation and operating manual as well as all
delivered product documentation.
Failure to comply with the warranty
conditions and the information listed in
this installation and operating manual
will void any warranty claims.
Prohibited uses
DANGER
Danger to life due to electric
shock!
Even if the utility grid fails, the
storage system will continue
delivering power. Before servicing
the storage system:
▶
Turn off the storage system.
▶
Turn off the main disconnect
circuit breaker.
Only authorized electrically
qualified persons can perform work
on electrical parts.
• Do not use the storage system in vehicles.
• Do not use the storage system in wet locations.
• Do not use the storage system in areas at risk
of explosion (flour dust, sawdust, etc.).
• Do not expose the storage system to direct
sunlight.
• Do not use the storage system in areas where
the ammonia content of the air exceeds 20
ppm.
• Do not use the storage system when corrosive
gases are present.
• Do not use the storage system higher than
9,842 feet (3,000 meters) above sea-level.
• Do not operate the storage system at
temperatures outside of the allowed ambient
temperature range of 41°F - 113°F (5°C - 45°C).
• Do not operate the storage system at a
humidity higher than 90%.
General warnings
Attention
ATTENTION
Damaging of the battery
modules by deep discharge!
If the battery modules are
disconnected from a power source
for longer than six months, they
can be damaged by excessive
discharge.
▶
If the storage system has been
disconnected from an AC source
for six months, connect it to the
AC power source and allow it to
charge the battery modules to
100%.
General safety instructions
• Do not modify the storage system.
• Do not use the storage system if it has been
damaged.
• Ensure the following regulations are observed
in the installation and connection of the
storage system and the PV system:
‒
Local, regional, national, and international
regulations and guidelines
‒
National Electric Code
‒
ANSI/NFPA 70
‒
Requirements of the servicing utility
• Ensure that all safety systems are in perfect