Sonifex NICA X, Reference Manual

Page: 21 / 64

NICA X Reference Manual
13
3.8 - Pin Protection
Quick Reference Table
MEANS OF
CONTROL MENU
REMOTE
CONTROL DIP
SWITCHES
ACTION - SYSTEM-CONFIG
- 9.PINS
- USER/CONFIG/SYSTEM
PST
There is a security PIN protection system in the NICA X which can be disabled or enabled. There are four levels of
PIN protection : User, Configuration, System Configuration and Remote Control. They all relate to the front panel
user interface apart from the Remote Control PIN which is to protect Remote Control of the NICA X. These are all
independently set with a 4 digit PIN protection number.
• The User PIN is required to perform a DIAL, or STOP, or BOOK dial function.
• The Configuration PIN is required to perform BOOK edits and Mode changes.
• The System Configuration PIN is required to access the System Configuration menus.
3.9 - Remote/Inband Control
Quick Reference Table
MEANS OF
CONTROL MENU
REMOTE
CONTROL DIP
SWITCHES
ACTION - SYSTEM-CONFIG
- 7.REMOTE
REM 3
Chapter 8 details the remote control commands available to the user on the RS232 Remote Control Port. Using the
auxiliary data channel, the NICA X can also control the remote end NICA X using Inband control. To control the
remote NICA X the Inband mode must be enabled as well as the auxiliary data on both units. The remote control
command to be sent to the local unit is prefixed with 0 (e.g. 0:STS) and the command to be sent to the remote
unit is prefixed with 1 (e.g. 1:STS).
There is also a Debug option in the Remote menu which allows the internal ISDN TA management port to be
accessed from the Auxiliary Data RS232 port. This is only used to change factory settings of the ISDN TA.