74
7
System Menu
IP Address
The IP address is split onto four encoder display sections. Pressing an
encoder cycles through the digits in the corresponding octet. Whilst a digit
is highlighted the encoder can be rotated in order to increase or decrease
the value. After all digits have been cycled an individual digit is no longer
highlighted and so changes can be saved. To discard changes select
Cancel
.
To save changes select
Save
, the unit will restart.
Netmask
Configure the subnet mask for this connection.
Gateway
Configure the gateway for this connection.
Primary
This port is used for Dante connections, this provides the same options as
the
Control
port.
Secondary
This port is used to provide redundancy to Dante connections if the port is
in redundant mode, this provides the same options as the
Control
port.
If the port is in switched mode these settings can still be changed, they will
be stored in the configuration file and loaded when the port is switched
back to redundant mode via the Dante controller application.
Brightness
Used to set the brightness of the TFT display, push button LEDs, status LEDs,
and encoder LED bars. Whilst in the brightness sub-menu all the encoder
LED bars are on, this allows the level of each of the colours to be seen.
Pressing the first encoder causes the percentage to be highlighted, the
brightness can then be adjusted by rotating the encoder. The brightness is
adjusted in 10% steps. Select
Cancel
to discard the changes or
Save
to keep
the changes.
Status
The status sub-menu provides a detailed list of the device’s current settings
and status. The following information is included in the list:
• Product ID
• Firmware Version
• Serial Number
• Friendly Name
• Control IP Address
• Control Netmask
• Control MAC Address
• Primary IP Address
• Primary Netmask
• Primary MAC Address
• Secondary IP Address
• Secondary Netmask
• Secondary MAC Address
• System Uptime
Config
Provides a list of currently available pre-set configs uploaded to the device.
When more configs are available than can fit in the menu each of the
encoders can then be rotated in order to move up and down the list.
Press down on an encoder in order to select the corresponding config. The
selected pre-set config is then marked with a tick. Selecting
Save
in this
sub-menu and then closing the menu will cause the unit to reboot and the
selected config to be loaded to the unit. Select
Cancel
to discard changes.
When loading a configuration from the system menu network settings are
not overwritten.
