47
Embedded Web Server
6
Lock
When a button has ‘Lock’ enabled pressing that button has no effect and
“Locked” will flash up in the top section of the TFT display. The LED will
continue to show the state the LED was in before ‘Lock’ was enabled. A
button can be locked in either the on or off state.
Action
This decides how the button behaves when pressed and when released.
The options available are described below.
Auto-Momentary
If the button is pressed and release quickly, the assigned function is
latched. When the button is pressed and released again, the function is
deactivated. If the button is pressed for longer than 350 milliseconds,
the button will then behave like a momentary button and the function is
instead active until the button is released.
Momentary
The function is active whilst the button is pressed until it is released.
Latching
The function is latched active when the button is pressed and released,
the button must then be pressed and released again to deactivate the
function.
Comm Pos
The ‘Comm Pos’ drop-down menu allows the user to select which
commentator microphone the selected function applies to. On the AVN-
CU2-DANTE this option ranges from 1 –2. On the AVN-CU4-DANTE, this
option ranges from 1 – 4.
On LED Colour / Off LED Colour
The colour of the LED when the function assigned to the button is active
(On LED Colour) or inactive (Off LED Colour) can be configured.
The following options are available:
• Off
• White
• Red
• Green
• Blue
• Yellow
• Cyan
• Magenta
Flash On T/B Or Cough
Enabling this option causes the associated On-Air button to flash when
either the T/B or cough button assigned to the same commentator position
are used.
Page #
The page to switch to when the button being configured is pressed, this can
be set to 1, 2, 3, or 4 on the first panel or to 5, 6, 7, or 8 on the second
panel (CU4 only).
Press & Hold for Off
To protect against the user accidentally deactivating a button (for example
the On-Air state) the “Press & Hold For Off” setting can be used. When this
setting is enabled, an active button must be pressed and held for 5 seconds
to be deactivated. The ‘Press & Hold For Off’ option overrides the ‘Action’
property to ‘Latching’.
