System settings
27
This section explains settings related to the system.
Explanations assume that the function setting state has
been enabled.
Enabling the function setting state
① Press and hold
.
Setting the automatic power off function
① Press
SYSTEM
, and select A.PWR.
② Turn the
VALUE
knob to select the automatic
power off setting.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• Automatic power off has four settings.
1.
OFF : Automatic power off is disabled.
2.
30 minutes (0.5 on display) : Power will turn off
automatically after 30 minutes without operation.
3.
1 hour (1H on display) : Power will turn off auto-
matically after 1 hour without operation.
4.
3 hours (3H on display) : Power will turn off auto-
matically after 3 hours without operation.
5.
6 hours (6H on display) : Power will turn off auto-
matically after 6 hours without operation.
• Unsaved data will be cleared when the power turns
off automatically. Always save data that is needed.
Setting the battery type
① Press
SYSTEM
, and select BATT.
② Turn the
VALUE
knob to select the type of bat-
tery.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• Two types of batteries can be selected.
1.
Alkaline (ALKL on display)
2.
Nickel-metal hydride (NIMH on display)
3.
Lithium (LTHM on display)
• The remaining charge shown could be higher than
the actual amount depending on the type of re-
chargeable battery.
• Please set this correctly because it effects opera-
tion time.
Setting the master tuning
① Press
SYSTEM
, and select TUNE.
② Turn the
VALUE
knob to set the master tuning.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The master tuning setting (in cents) will be shown
on the display.
• The adjustment range is － 75–+75.
Setting the clock source
① Press
CLOCK
, and select SRC.
② Turn the
VALUE
knob to set the clock source.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The clock source is shown on the display.
• Four types of clock sources can be selected.
1.
INTERNAL (INT on display) : Use LIVEN 8bit
warps internal clock
2.
MIDI : Use clock from MIDI
3.
SYNC : Use SYNC IN clock
4.
LINE IN (LN.IN on display) : Use clock from LINE IN
Setting the polarity of SYNC IN
① Press
CLOCK
, and select S.I.PO.
② Turn the
VALUE
knob to set the clock source.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The clock source is shown on the display.
• Two types of polarity can be selected.
1.
FALL : Synchronize with the fall of synchroniza-
tion signal
2.
RISE : Synchronize with the rise of synchroniza-
tion signal
Setting the polarity of SYNC OUT
① Press
CLOCK
, and select S.O.PO.
② Turn the
VALUE
knob to set the clock source.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The clock source is shown on the display.
• Two types of polarity can be selected.
1.
FALL : Synchronize with the fall of synchroniza-
tion signal
2.
RISE : Synchronize with the rise of synchroniza-
tion signal
