11
SONAMP DSP 2-150 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL
Quick Setup
Follow the Network Setup instructions to access the
software.
General Settings Tab - Auto On
Select the AUTO ON method you would like to use.
NOTE: IF EITHER AUDIO OR VOLTAGE TRIGGERS ARE SELECTED, THE
AMPLIFIER HAS A 12 SECOND CYCLE TIME FROM STANDBY TO PLAY
AN AUDIO SIGNAL. THIS IS NORMAL AND REQUIRED TO COMPLY
WITH THE EU < .5 WATT ERP DIRECTIVE. (EC/1275/2008). SELECT
OFF TO BYPASS THIS FEATURE. SEE POWER CONSUMPTION TABLE
FOR IDLE POWER USE (SEE PAGE 6, FIGURE 7). AUDIO AUTO ON
IS THE ONLY MODE THAT ALLOWS THE AMPLIFIER TO DRAW 0.5
WATTS AT STANDBY.
NOTE: WHEN VOLTAGE, POWER BUTTON, IP OR IR IS SELECTED THE
AMPLIFIERS POWER SAVING FEATURE WILL BE DISABLED.
In/Out Settings Tab - Output Setup
Select the preloaded DSP preset that matches your
Sonance speaker.
If the DSP preset for your Sonance speaker is not included in the
amplifier, follow the instructions to the right to add DSP presets.
In/Out Settings Tab - Output Source
The amplifier default is Input 1 to Output 1, Input 2 to Output
2, etc. If your application is different, assign the correct input to
each of the output channels you will be using. Any left Input can
be assigned to any left Output. Any right Input can be assigned to
any right Output.
In/Out Settings Tab - Output Volume
If you are using a control system to adjust the volume you can skip
these steps.
1. Set the Output Volume for each channel.
2. Set the Turn On Volume the same as the Output Level.
a. Its important to set the Turn On Volume the same in
case the amplifier power is shut off accidentally.
The basic setup is complete!
Apply DSP Preset
Follow the Network Setup instructions to access the
software if not completed already.
Each Sonance DSP amplifier has 50 slots with pre-configured DSP
curves for Sonance speaker models pre-loaded. If the speaker
model in your application is not on the pre-loaded list, hundreds
of DSP files are available for download from the Sonance website.
Sonance Website
Download the preset for your specific Sonance speaker model
at www.sonance.com/electronics/amplifiers/dsp
DSP presets are also available for download on individual speaker
web pages.
Save the new preset in a location on your computer you will be able
to find later.
EQ Settings - Tab
1. In the blue box labeled SELECT EQ PRESET choose which preset
number you would like to use to store your new EQ Preset.
You can overwrite presets you will not use.
2. Press the Green Import Single EQ Preset button.
3. Select the file you downloaded from the Sonance website.
4. The file will now be loaded into the preset location you
have selected.
5. If necessary edit the name of the preset.
In/Out Settings Tab - Output Setup
Select the new EQ Preset from the drop down list and apply it to the
appropriate amplifier channels.
Your new EQ preset has been applied!
You can now apply the EQ preset to the channel on the EQ Settings
page at the top.
Quick Setup Page
If you will be using the Sonance DSP amplifier with a control system and only want to make basic changes to the software these
instructions will guide you through the process.
