Caution: Risk of electric shock!
Do not attempt to disassemble of modify the unit or its
accessories. In case any part is damaged, immediately power off the unit and seek the assistance of
a specialist.
In the event that the power cable should become damaged, it should only be replaced with cables
obtained from the manufacturer or its service facility.
FEATURES
dehumidification max. 250 ml/day (25 °C, 85% RH) • Peltier-system, no compressor, no air conditioner gas • 0,5-liter water tank • switches off automatically when the
water tank is full • non-slip rubber soles • easy, compact, silent appliance
SETUP
(Figure 1.)
1. indicator LEDs
2. main switch
3. air openings
4. water tank
5. power adaptor socket, 9 V
INSTALLATION
1. Remove the packaging carefully taking care not to damage the plastic body with scissors or knife.
2. Make sure the appliance has not been damaged in transit!
3 Place the appliance only onto a stable and horizontal surface!
4. Always keep the minimum installation distances indicated in Figure 2. Always observe the health and safety regulations valid in the country of use!
5. Connect the power adaptor to the appliance!
6. Connect the power adaptor to 230 V~ / 50 Hz electric wall outlet.
7. After connecting the unit to power source, it is ready for operation.
USING YOUR DEVICE
The appliance can be switched on and off with the toggle switch, located on the front of the unit.
After switching the unit on, the built-in fan draws the air in through the openings at the front, then blow it out at the top. The
green ON
(switched on) LED is lighting.
The air, flowing in the device is in contact with cold metal plates and a portion of the vapour condenses. The water which is condensed this way will be collected in the
water tank. If the water tank is full,
FULL
LED lights up in
red
, and the machine stops operation.
WATER TANK DRAINING
Switch off the unit before draining the water tank, and unplug it from the power outlet.
Remove the water tank of the appliance. Pull out the rubber plug, situated at the corner of the water tank, and pour out the collected water. Place the rubber plug back,
then push back the water tank to its proper place. Reinstall the unit again!
CLEANING
In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending on the manner of use and degree of contamination.
1. Switch off and power off the unit by unplugging it from the electric outlet, before cleaning!
2. Use a slightly moistened cloth to clean the unit’s exterior. Do not use any aggressive cleaners. Avoid getting water inside of and on the electric components of the
appliance!
3. Reinstall the appliance!
TROUBLESHOOTING
SPECIFICATIONS
power supply, power adaptor
: PRI: 230 V ~ / 50 Hz • SEC: 9 V / 3 A
output
:. . . . . . . . . . . . . . . . . 23 W
electric shock protection class
: III.
noise level
: . . . . . . . . . . . . . 40 dB(A)
dimensions
:. . . . . . . . . . . . . 15,4 x 22 x 13 cm
length of connection cable
: . . 1,2 m
weight
: . . . . . . . . . . . . . . . . 0,85 kg
Malfunction
Solution
Device doesn’t switch on
.
Check the power supply
!
Check the switch!
Device does not collect vapour.
Check the location of the appliance (Figure 2.).
Air might not humid enough.
