5
27. Lead the power cable so as to prevent it from being pulled out accidentally, and do not let it hang
over the edge of a table!
28. Heating elements / heated surfaces of the appliance are still warm for a while after the unit has been
switched off.
29. After switching off the appliance, do not pull out the thermostat connector from the device, since it is
hot! Let it cool down together with the griller surface, and pull out afterwards!
30. Switch off the appliance after every use, and unplug the power cable! Store the appliance at dry,
cool place!
31. The unit is intended for household use only. No industrial use is permitted!
Caution: Risk of electric shock!
Do not attempt to disassemble or modify the unit or its acces
-
sories. In case any part is damaged, immediately power off the unit and seek the assistance of
a specialist.
In the event that the power cable should become damaged, it should only be replaced with ca
-
bles obtained from the manufacturer or its service facility.
INSTALLATION
1. Before installation, carefully remove the packaging, and make sure not to damage the unit or the
connecting cable. If you find any damage, the unit must not be operated!
2. Clean the grilling surface first with a detergent, then with a clean sponge, then wipe it dry.
3. Place the product on a solid, horizontal, heat-resistant surface.
4. Always keep the minimum installation distances indicated in Figure 2. Always observe the health and
safety regulations valid in the country of use!
5. Slide the oil drip tray to its place.
6. Connect the thermostat to its socket till it clicks. The control button should face upwards.
7. Plug the unit into a standard grounded wall socket! Now the unit is ready for operation.
8. Set the thermostat to maximum (Max.) and wait for 10 minutes.
9. Switch off heating by turning the thermostat to 0 position.
10. After that the appliance is ready for use.
CLEANING, MAINTENANCE
1. Switch off heating by turning the thermostat to 0 position.
2. Switch off and power off the unit by unplugging it from the electric outlet before cleaning!
3. After switching off the appliance, do not pull out the thermostat connector from the device, since it is
hot! Let it cool down together with the griller surface, and pull out afterwards!
4. Clean the surfaces got in touch with food after every grilling! Use a slightly moistened cloth or kitchen
paper towel to clean the outside of the unit. Do not use aggressive cleaners!
5. Avoid getting water inside of and on the electric components of the appliance!
6. It is prohibited to immerse the unit to water!
7. Pull the oil drip tray out of its place, pour out the grease. Wash the oil drip tray by hand, wipe it dry
and put it back to its place.
ATTENTION! The gathered material in the oil drip tray cannot be consumed!
8. Wipe the thermostat connection dry!
X
