SOMFY YSLO FLEX RTS 1P, Installation Manual, Page: 25 / 28

Copyright © 2012 - 2014 Somfy SAS. All rights reserved.
Yslo Flex RTS 1P
25
18.2. Maintenance operation requiring the housing to be unclipped
18.2.1. Restoring the original configuration
Restoring the original configuration deletes all the control points as well as the saved sensors and
favourite position, and the buzzer is deactivated.
• Press and hold the button no. 4 on the Yslo Flex RTS 1P
board:
- The panel makes a first back-and-forth movement
with a beep and then a second back-and-forth
movement with 2 beeps a few moments later.
The original configuration is restored at the end of the
second back-and-forth movement.
18.2.2. Replacing the battery
Refer to the Yslo Flex battery After-sales kit guide.
there is a risk of explosion if the battery is replaced with an incorrect battery type. Dispose of used
batteries in accordance with the instructions.
Please separate the storage cells and batteries from other types of waste and recycle them via
your local collection facility.
In the event of a power outage, you can use your swing shutter thanks to the integrated battery,
however, the buzzer keeps beeping throughout the movements.
The battery can operate for 20 movements maximum.
18.2.3. Replacing a lost or broken control point
• To replace a lost or broken control point, unclip the housing and repeat the commissioning procedure.
See Section " Commissioning ".
19. Technical data
Yslo Flex RTS 1P
Size W = 95 mm - H = 70 mm
Reveal width (Wr) 590 mm ≤ Wr ≤ 900 mm
Radio frequency 433.42 MHz
Power supply 230 V ~ 50 Hz
Operating temperature - 20°C to + 60°C
Safety level Category II
Protection rating IP 24
Maximum rotation speed in shaft output 1.5 rpm
Maximum number of associated RTS control points 12
Maximum number of associated RTS sensors 3
BIP
BIP... BIP
≈ 7 s
BIP
BIP... BIP