SOMFY YSLO FLEX RTS 1P, Installation Manual, Page: 17 / 28

Copyright © 2012 - 2014 Somfy SAS. All rights reserved.
Yslo Flex RTS 1P
17
8. Commissioning and saving the RTS control point
Upon power-up, if Yslo Flex RTS 1P beeps, check the battery connection.
Battery operation is not possible for the first 20 operations.
You must switch on the mains supply before any operation.
ON
1) Press and hold the button no. 4 on the Yslo Flex RTS 1P
board until it beeps.
2) Take the RTS control point
The shaft of the panel makes a rotation.
3) Briefly press the PROG button on the RTS control
point: the shaft of the panel makes a rotation and
Yslo Flex RTS 1P beeps twice, and the control point is
saved in Yslo Flex RTS 1P.
4) Press the ON/OFF button to turn on or turn off the
control point.
Do not press the sensitive side of the control point
against your hand to avoid triggering accidental orders.
9. Checking and adjusting the rotation direction
- Press the button on the RTS control point until the
output shaft rotates:
a) If the output shaft rotates in the opening direction, the
rotation direction is correct. Go to the step "Installing
stoppers".
b) If the output shaft rotates in the closing direction, the
rotation direction is not correct.
1) Press and hold the button no. 3 on the Yslo Flex RTS 1P
board:
- The output shaft moves back and forth with a beep:
the rotation direction has been modified.
2) Press the button on the RTS control point to check
the rotation direction.
1
BIP
BIP... BIP
3
4
2
2 s
BIP
BIP... BIP
a
b
2
1
OK
≈ 5 s
BIP
BIP... BIP