SOMFY YSLO FLEX RTS 1P, Installation Manual, Page: 11 / 28

Copyright © 2012 - 2014 Somfy SAS. All rights reserved.
Yslo Flex RTS 1P
11
Before installing Yslo Flex RTS 1P, the swing shutter must be capable of being opened or
closed without difficulty and the lintel must be level in width and depth.
2. Positioning Yslo Flex RTS 1P
1) Close the shutter
2) Draw a pencil line along the lintel following the inside of
the closed shutter
3) Place the first bracket
c
against the lintel 10 mm away
from the pencil line towards the inside and mark the
holes
4) In the same way, position the second bracket on the
opposite end and mark holes.
3. Drilling the bracket mounting holes
The anchors used must be able to withstand forces of at least 40 kg. The brackets must be
fixed in at least two points.
Somfy recommends that you use screws with a diameter of at least six millimetres.
The choice of the fixing method depends on the nature of the support, and therefore, it will be
under your sole responsibility.
• Drill the holes and fix the first bracket.
If the lintel is more than 690 mm wide, drill the holes in the same way and fix the second bracket
on the opposite end.
After opening the kit, separate the housings from the modules.
c
10 mm