SOMFY YSLO FLEX RTS 1P, Installation Manual, Page: 21 / 28

Copyright © 2012 - 2014 Somfy SAS. All rights reserved.
Yslo Flex RTS 1P
21
3) Cut the sliders to the width of the panels (
l
)
minus 55
mm.
In case the panel is more than 790 mm wide, do not cut
the slider.
13.2. Installing the arm
1) Choose the arm from the kit.
2) Install the roller at the end of the arm and tighten the
roller slightly with two 8 mm wrenches.
Depending on the roller’s installation, the arm
becomes the left arm or right arm.
3) Position the hexagonal hole of the arm opposite the
motor output shaft
To observe the direction of installation of the arm, the
roller must face upwards.
4) Tighten the assembly with the screw and the washer
o
to drive in the arm
It is necessary to use the washer.
5) Place the cover
o
on the screw head (supplied).
6) Place the arm in half-open position using the RTS
control point.
13.3. Installing the slider on the panel
1) Slide the slider
k
over the arm roller.
In order to observe the direction of installation, the slider
must be positioned with the channel facing downwards.
2) Push the end pieces
j
into the ends of the slider.
3) Using a spirit level, you must centre the slider horizontally
on the width of the panel.
Installation with batten: using a spirit level, you must
position the slider horizontally such that it touches the
outer edge (the one opposite the hinges) of the panel.
The end pieces of the slider
j
must not protrude
l
- 55 mm
o
o
k
j j
m
m