Sonesse Ultra 50 - Sonesse Ultra 50 RH
EN
51
Copyright
©
2014 - 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
1.2 LIABILITY
Before installing and using the motor, please read
operating and installation guide carefully
.
In addition to following the instructions given in this guide, the instructions detailed in the
attached
Safety instructions
document must also be observed.
The motor must be installed by a motor and home automation professional, according
to instructions from Somfy and the regulations applicable in the country in which it is
commissioned.
It is prohibited to use the motor outside the
¿
elds of application described above. Such use,
and any failure to comply with the instructions given in this guide and in the attached
Safety
instructions
document, absolves Somfy from any liability and invalidates the warranty.
The installer must inform its customers of the operating and maintenance conditions for the
motor and must provide them with the instructions for use and maintenance, and the attached
Safety instructions
document, after installing the motor. Any
After-Sales Service operation on
the motor must be performed by a motor and home automation professional.
If in doubt when installing the motor, or to obtain additional information, contact a Somfy adviser
or go to the website www.somfy.com.
2. INSTALLATION
Instructions which
must
be followed by the motor and home automation professional installing the
motor.
Never drop, knock, drill or submerge the motor.
Install a separate control point for each motor.
To optimize ultra
T
uiet operation, the mechanical plays between motor, accessories, tube and end of
tube must be decreased to the maximum.
2.1. INSTALLATION
2.1.1. Preparing the motor
Check that the inner diameter of the tube greater than 47mm.
1) Fit the accessories required to integrate the motor in the roller
tube:
• Fit the crown
a
, the motor wheel
b
and the stop wheel
c
on the
motor.
The stop wheel must be screwed with a torque ranging between
1.5 and 1.8 Nm.
2) Measure the length (L1) between the inner edge of the motor
head and the edge of the motor wheel.
2.1.2. Tube preparation
1) Cut the roller tube to the required length, depending on the
motorised product.
2) Deburr the roller tube and remove the swarf.
1)
2)
1
1
1
Safety warning!
Information
ȁ
Up
V
Down
1
Caution!
1
1)
L1
L1 = …
2)
Ø > 47 mm
b
a
c
Sonesse Ultra 50_5120788C004.pdf 51
Sonesse Ultra 50_5120788C004.pdf 51
7/25/2019 8:39:49 AM
7/25/2019 8:39:49 AM
