SOMFY Movelite WireFree RTS Instructions Manual Download Page 4

Page: 4 / 140



2. INSTALLATION

Instructions which

must

be followed by the drive and home automation professional installing the

Movelite

WireFree

motor.

Never drop, knock, drill or submerge the drive.

Install a separate control point for each drive.

Safety warning!

Information

Caution!

2.2. BATTERY PACK INSTALLATION AND CHARGING

2.2.1. Connection of the battery pack to the motor (Fig 3)

1) Insert battery pack till hear a clicks to lock. If battery pack is not weak, motor will emit one “beep” and

LED will green blink for several seconds, then motor is ready to work.
If battery pack is weak, motor will emit one “beep” and LED will red blink for several seconds, charge it

refer 2.2.2

2.2.2. Charge of the battery pack (Fig 4)

To ensure electrical safety, this Class III motor must be powered by a «SELV» voltage

source (Safety Extra Low Voltage).

Do not use any power charger to charge from the top of battery pack

The battery level must be below 30% before shipping by air.

Use only 5V, <=2A USB charger provided by Somfy to charge the battery pack.

See below table for detail.

The motor can be used while charging

1) Connect the micro USB to the bottom of battery pack.

2) After connecting the power charger to the battery pack, the LED on the battery pack will be red. This is

the charging mode,

3) When the LED turns green, the charge cycle is complete.

Disconnect the power charger, and save it for later use.

2.1. INSTALLATION

2.1.1. Installation of the rail (Fig 1)

1) Mark the position of the brackets.
2) Drill the ceiling or the wall at the right places.
3) Attach the brackets.
4) Attach the rail on the brackets.

2.1.2. Installation of the motor (Fig 2)

1) Unlock the motor
2) Insert the motor shaft into the drive pulley hole.
3) Lock the motor.



For the illustration, see page 134.

2.3. COMMISSIONING

2.3.1. Pre-programming the RTS remote control (Fig 5)

1) Connect battery pack to the motor, refer to 2.2.1.
2) Press the

Open

and

Close

buttons on the RTS remote control at the same time: The motorised product

moves briefly, and the RTS remote control is pre-programmed in the motor.

2.3.2. Setting the end limits

At the first command Open or Close, the motorised product make a first run to record the hard stop position.
If need to adjust end limits, refer 2.4.2

2.3.3. Checking the direction of rotation (Fig6)

1) Press the

Open

button on the RTS remote control:

a) If the motorised product opens (a), the direction of rotation is correct.
b) If the motorised product closes (b), the direction of rotation is incorrect: Move onto the next step.

2) Press the

button on the RTS remote control until the motorised product moves: The direction of

rotation has been modified.
3) Press the

Open

button on the RTS remote control to check the direction of rotation.

If need to change the direction of rotation, refer 3.4.4

2.3.4. Recording the RTS control point (Fig 7)

Press the PROG button on the back of the remote control until the motorised product moves. The remote

control address is permanently recorded.

2.3.5. Adjusting the Touch motion sensitivity (Fig 8)

Move the motrised product away from the end limits.

1) Press the