SOMFY HOME MOTION Twipso io, Manual

Page: 32 / 52

6
EN
Copyright © 2014 Somfy SAS. All rights reserved - non-contractual images.
2. 3. 1. Setting and resetting the Angled out/Angled in zones
1)
Mark a zone (Za) between 940 mm and 960 mm from
the top of the guide rail to identify the tipping device's
lowest point (Angled out).
2) Mark a second zone (Zb) between 720 mm and
740 mm from the top of the guide rail to identify the
tipping device's highest point (Angled in).
3) Press
V
and allow the apron to unwind down to the
bottom.
1
The roller shutter must be in the lower position at this
point.
4)
Simultaneously press and
V
until the roller shutter
moves back and forth @KQX
5) Position the lower part of the end slat in the middle of
‚@X›ˆ›žˆ
the top of the guide rail using
and
V
.
6)
Simultaneously press
my
and
angled out position. The roller shutter moves back
and forth.
7)
Position the lower part of the end slat in the middle of
the second zone (Zb) between 720 mm and 740 mm
from the top of the guide rail using
and
V
.
8) Simultaneously press
my
and
V
Ž !
back and forth.
9)
Press
my
@K[X moves
back and forth Ž!ƒ
- If the roller shutter does not move back and forth, repeat the steps in the " Setting and
resetting the Angled out/Angled in zones " section.
2. 3. 2. Testing the Angled out/Angled in position
1) Test the Angled out/Angled in position by pressing the
Smoove Tw io Angled out/Angled in switch.
b) If the roller shutter performs the Angled out/
Angled in sequence: go to the "
OPERATION AND
MAINTENANCE " section.
c) If the roller shutter does not perform the Angled out/
‰ # ! ƒ
forth: go to the "
Setting and resetting the Angled
out/Angled in zones " section.
1)
3)
5)
7)
9)
2)
4)
6)
8)
> 2 s.
960 mm
940 mm
740 mm
720 mm
Za
Za
Zb
Zb
" OPERATION AND
MAINTENANCE "
a
b
1)
"Setting and resetting
the Angled out/Angled
in zones"