SOMFY HOME MOTION Twipso io, Manual

Page: 30 / 52

4
EN
Copyright © 2014 Somfy SAS. All rights reserved - non-contractual images.
2. 1. 4. Mounting the tube-drive assembly
1)
Fit and attach the tube-drive assembly to the end
support
f
and the drive support
g
.
1
Make sure that the tube-drive assembly is locked in
place at the end support. This prevents the tube-
drive assembly from coming out of the end support
2) `!
h
in place.
2.2. WIRING
Cables routed through a metal wall must be protected and insulated by sleeving or
sheathing.
Secure the cables to prevent any contact with moving parts.
The cable of the Twipso io is removable. If it becomes damaged, replace it with an identical
cable.
1
Leave the drive power supply cable accessible: it must be easily replaceable.
1
Always make a loop in the power supply cable to
prevent water from entering the drive!
-
Turn off the mains power supply.
-
Connect the drive according to the information
provided in the table below:
230 V 50 Hz Cable
1 Phase (P) Brown
2 Neutral (N) Blue
3 Earth ( ) Green-Yellow
2.3. SET-UP
This guide describes set-up with a Somfy Smoove Tw io control point.
1
Power must only be supplied to one drive at a time.
Turn on the power and follow procedure A or B proceed according to the roller
shutter's reaction:
1)
2)
g
f
h
1
2
3
1
2
3
OFF
230 V
50 Hz
3 x 1.5 mm
2
3 x 0.75 mm
2
ON