SOMFY HOME MOTION Twipso io, Manual

Page: 34 / 52

8
EN
Copyright © 2014 Somfy SAS. All rights reserved - non-contractual images.
2. 4. 2. Replacing a lost or broken Smoove Tw io Somfy io control point
1
Apply the double cutout only for the end-product to
be reset.
This reset deletes all io-homecontrol
®
local control
points; however the sensors, end limit settings and
favourite position are retained.
1)
Position the roller shutter at its half-way
position.
2) Cut the power supply for 2 seconds.
3)
Switch the power supply back on for 5 to 15 seconds.
4)
Cut the power supply for 2 seconds.
5)
Switch the power supply back on: the roller shutter
moves for a few seconds. (If the end-product is in
the upper or lower end limit position it will move back
!X
6) Press the
PROG
button on the new io control point
until the roller shutter moves back and forth : the
new control point is programmed and all the other io
control points are deleted.
2. 4. 3. Modifying the rotation direction
Ž!
the programmed Smoove Tw io:
1)
Position the roller shutter 20 cm (x) from the top of
the guide rail.
2)
Simultaneously press and
V
until the roller shutter
moves back and forth @KQX
3) Press
my
until the roller shutter starts to move again:
4) Press to check the new rotation direction.
This operation deletes the Angled out/Angled in
zone setting. Go to the "
Setting and resetting the Angled out/Angled in zones " section
to perform the settings again.
2. 4. 4. %
1
Apply the double cutout only for the end-product to
be reset.
1
This reset deletes all programmed control points, all
sensors, all end limit settings and resets the
favourite position (my) for the drive.
1)
Position the roller shutter at its half-way position.
2) Cut the power supply for 2 seconds.
3) Switch the power supply back on for 5 to 15 seconds.
4) Cut the power supply for 2 seconds.
5) Switch the power supply back on: the roller shutter
moves for a few seconds.
6)
Press the PROG button on the Somfy io-homecontrol ®
local control point for K 7 seconds, until there
are two back and forth movements by the roller
shutter:
] Ž!
-
Resume the set-up operation (see Set-up section).
my
2 s
2 s
15 s
5 s
1)
5)
3)
2)
4)
OFF
OFF
ON
ON
6)
1)
3)
2)
4)
x
6)
PROG.
7
S
my
2 s
2 s
15 s
5 s
1)
5)
3)
2)
4)
OFF
OFF
ON
ON