4
EN
Affixing the label to the electronic unit
►
The label (20) should be affixed to the motor’s electronic unit (3).
switching the installation on
►
Switch the installation on.
The STATUS
indicator on the electronic unit will flash (2 pulses) to indicate that the motors are
on and awaiting setting.
If the STATUS indicator stays out, see page 20.
Memorising a 2 or 4 button remote control
►
[1].
Place the remote control to be memorised on the target.
[2].
Briefly press the button on the remote control that will control the COMPLETE opening of
your gate.
> The RADIO
indicator will come on
then go out when you release the button
on the remote control.
The button has been memorised.
Programming the gate travel
►
The motor's electronics automatically store:
The motor torque required to control the
•
gate, in normal operation. Once this is
stored, this enables any abnormal motor
effort to be detected.
The travel distances required to fully open and
•
close the gate with the positions of the end
stops.
During programming, you should remain at a
normal distance from the gate and follow the steps
below:
Press button 1
on the remote control
to initiate a coMPlEtE opening/closing
motion of the gate.
the status indicator
of the electronic
unit must be CONTINUOUSLY LIT.
If the STATUS indicator
is flashing, refer to
the troubleshooting section on page 30.
The gate movements must not be interrupted
(complete opening/closing).
If they are interrupted, programming will resume the
next time the opening command is made.
1
2
Quick coMMissioning
RESET
30s
RESET
30s
<0,5s
Button 1
Button 2
