Thymatron
®
System IV Instructions for Use
53
This feature allows for previously recorded treatment data to be sent back to the Thymatron® System IV. Once
the data has been received back in the Thymatron® System IV, it can then be reprinted using the “REPRINT”
option in the “DATA OUT” function level.
1.
Press
the
FlexDial
™ to display the most recently adjusted
FlexDial
™ function.
2.
Rotate
the
FlexDial™
until “DATA IN” is displayed.
3.
Press
the
FlexDial™
once; “DATA IN” will flash-display.
4.
Press
the
FlexDial™
again; “IN” will flash-display.
5. On the PC, from the GENIE™ IV main menu, click on FILE OPEN. Highlight the file to be sent and click
OPEN. From the main menu, click on CONNECT SEND DATA.
6. Transfer is complete when the display stops flashing and returns to “DATA IN”.
7.
Press
the “IMPEDANCE TEST”
or “START/STOP” button to exit the
FlexDial™
mode.
This treatment data will now replace that of the last treatment given and will stay in the Thymatron® System IV
memory until the unit is turned off or another treatment is given. To reprint this treatment on a paper record, see
the DATA OUT section below.
UPLOAD TREATMENT DATA AUTOMATICALLY TO A PC
This feature allows for the automatic transfer of the treatment data to a PC after the printed end-of-treatment
report. The PC must be connected to the Thymatron® System IV and the Genie™ IV software tool opened to the
correct function; please review the GENIE™ IV manual for further details. The options are as follows:
LOAD OFF
Disables UPLOAD function and no data will be transferred.
LOAD RAW
Sends all EEG data, including the FFT points and end-of-treatment report.
LOAD FFT
Sends all FFT points and end-of-treatment report.
LOAD TXT
Sends ASCII file of the end-of-treatment report.
FLEXDIAL™ UPLOAD: LOAD OFF, LOAD RAW, LOAD FFT, LOAD TXT
1.
Press
the
FlexDial
™ to display the most recently adjusted
FlexDial
™ function.