Solution SLE40i, Instruction Manual

Page: 13 / 20

13
Operation Continued
Fig.25 Flame Operation
By pressing the Flame Picture button, you can select from
four different Flame Picture options -see Fig 25:
-- No Flame Picture
FE
Flame & Fuel Bed - (Icon is on LCD screen)
-E
Fuel Bed Only - (Icon is on LCD screen)
F- Flame Only- (Icon is on LCD screen)
NOTE: When one of these modes has been selected, this
mode will be the default mode when the unit is turned
on by manual or remote operation.
NOTE: Heater can only be turned ON when either the
flame and/or fuel bed (F or E) is ON.
Fig.26
Fuel Bed Brightness Operation
The brightness setting of the Fuel Bed can also
be adjusted by pressing the Brightness button
to select from the following levels - see Fig 26:
H = High
Maximum Setting
C = Central
Intermediate Setting
L = Low Minimum Setting
NOTE: Icon flashes on LCD screen when
the brightness is being adjusted.
Fig.27 Flame Brightness Operation
The brightness setting of the Fuel Bed can also
be adjusted by pressing the Brightness button
to select from the following levels-see Fig 27:
H = High Maximum Setting
C = Central Intermediate Setting
L = Low
Minimum Setting
NOTE: Icon flashes on LCD screen when
the brightness is being adjusted.
NOTE: If the appliance is turned off when ‘- -’ no flame picture has been selected, then no flame
picture will appear when turning the fire back on. Simply press the flame operation button again to
see your fire operate.