3.5.2 USING THE STUDIOBOX
About the headphones into the Studio
The Solidyne HD5 accessory manages up to five
headphones with independent level knobs.
HD3 allows to connect up to 3 headphones and
has two level knobs. Headphones 2 and 3 are
twins, sharing the level control.
The maximum volume delivered is determined by
the headphone level control in the MONITOR sec-
tion of the UX24. What is heard depends on the
signal selection made in the console.
About the loudspeakers into the Studio
The output for Studio speakers has a level control.
StudioBox have dual A/B monitoring channel.
Channel A is fed from the “Studio Monitor” connec-
tion, so the signal heard depends on the assign-
ment on the console. Channel B receives the signal
from the aux input (AUX Monitor Input).
NOTE: SPEAKER MONITORS LEVEL
Set the volume using the speakers knobs for a comfort-
able listening, leaving the LOUDSPEAKER LEVEL knob of
the StudioBox at center position.
About the Studio Intercom
The white button have two functions:
1.
When the microphones are turned off, press-
ing the Studiobox Intercom who is in the Stu-
dio can speak to the Control Room. Stu-
diobox has a contact microphone for this
purpose. At the Control Room, the operator
will listen the signal by the console's CUE
channel. The internal mic gain is adjusted
with the preset “mic gain”. In the console
surface,
the knob CUE level has no action on
the HD3/HD5 mic signal
, so that the Inter-
com will heard even if the CUE volume is
zero. The operator will use the talk-back as
is usual to talk with the Studio.
2.
When the mics are on the air, the Intercom
button only works as a tally light.
NOTE
MIC GAIN: The preset located below the mic allows to
set the mic gain and therefore, the listening level for
the operator at the Control Room.
About the Timer/Clock
(only HD5)
Displays the current time (when the Studio is off-
air) or the time spent on-air (when the micro-
phones are on-air).
The counter mode can be dissabled. For this, re-
move the cover of the HD5 and remove an internal
jumper located next to the clock. This will disable
the counter feature, and the display will always
shows the current time.
Page 20
Solidyne UNIDEX UX24